Handling and Storage of PE Gas Pipelines and Accessories

Handling and Storage of PE Gas Pipelines and Accessories

The storage area should be smooth and flat. For ease of handling and to avoid damage, the pipe package should be placed at a frame spacing of approximately 2 meters on the center of the wood to match the package. Attention should be paid to the long-term stacking height limitation, and the tendency towards creep loads required for straight pipes and less than 2 meters of wood frames. (or if the diameter is greater than 3 times).

The important thing is to keep the frame packages aligned and vertically stacked alternately and evenly, where the stack of building blocks is located. There should be a large difference in frame spacing between packages, and wooden sedan chairs should not be stacked side by side, effectively increasing the load between the stacks in the bearing area and the load at the time point. It is neither feasible nor advisable to carry vertically aligned stacks and then transport them with unstable longitudinal sliding. In addition, at all stack heights, there will be a significant increase. Provide appropriate consideration for lateral stability (such as wind force), which typically means that packages with a width of 1.2 meters may be stacked up to a height of 3 meters.

The coil is usually transported and stored in a vertical plane shortly after, although this may be subject to guaranteed availability and safe preservation of the tilted coil. If stacked horizontally, they should be placed on pallets with convenient lifting slings. The coils stacked in this way should also be limited to a height of 1.0 meters. Polyethylene PE gas pipelines with black or white pigments have extremely good UV radiation resistance. However, blue, orange, and yellow pigment tubes may fade if stored under direct sunlight for 6 months, so they should be covered for a longer storage period. Pipelines that exhibit significant decline should not be used in high stress applications. In any case, the pipeline should be covered with black plastic cloth in an open area.

On June 20, 2017, obtained the appearance design patent certificate "Combined Tee with Sheath".